Get exclusive MADE IN PAKISTAN STEM kits FOR YOUR KID New kits EVERY MONTH WITH FREE SHIPPING!!!!!!!!!!
Heat Hawk
Feel the Heat. Sense the Change
Haseeb
What if your room could tell you when it's getting too hot before you even notice it?
In this exciting Arduino project, you will build your own Heat Hawk Temperature Detection System using an Arduino UNO, a DHT11 temperature and humidity sensor, an OLED display, an LED, and a buzzer.
Your device will continuously monitor the surrounding temperature and humidity, displaying live readings on the OLED screen.
But here's the exciting part! When the temperature rises above 27°C, Heat Hawk will automatically activate its LED and buzzer alarm to warn you about the rising heat.
Can you build a smart device that senses temperature, detects danger, and reacts before you do?


Let's build it!
REQUIRED COMPONENTS
Circuit Connections
Connect the components according to the following pin configuration.
LED
DHT 11
Long leg of LED goes to DIGITAL PIN D3
Short leg of LED goes to GND
OLED
GND
GND
VCC
5V
SCL
A5
SDA
A4
OLED has two pins for POWER
The other two pins are for I2C COMMUNICATION
Buzzer
Short Leg
GND
Long Leg
D2
Long leg of the buzzer is D2
Short leg of the buzzer is NEGATIVE


GND
GND
VCC
5V
DATA
A1
DHT 11 has two pins for POWER
The other pin is for SIGNAL
Long Leg
D3
Short Leg
GND
